| Sterilizer Manufacturer: Market Forge |
| Model of Sterilizer: Market Forge STM-E |
|
Problem Title:
low water indicator stays on |
|
Problem Description:
We have a Market Forge STM-E. When we try to run a cycle, the sterilizer works normally until temperature is reached. Then the low water indicator light comes on and the sterilizer shuts off. After the temp and pressure go down, when we open it, it still is full of water and we can usually reset using the button, but then it happens again when we try to run it. At first the problem was intermittent, and we could sometimes run a complete cycle, but now it's doing it every time. Sometimes we can't even reset it and have to wail until it is significantly cooled down before the reset button will work. |
| Reasons |
| 1. The low water cut off is faulty. |
|
Solutions |
| 1. Replace low water cut off. |
|
|
|||||
|
The technical information is just to help sterilizer users as reference to do their trouble shooting. no guarranty implied. For each specific technical help to do with sterilizers or autoclaves, go to www.sterilizers.com ... or call 1-800-801-9934 Contact Us |