| Sterilizer Manufacturer: Tuttnauer |
| Model of Sterilizer: Tuttnauer 2340M/MK |
|
Problem Title:
Tuttnauer 2340M will not heat up |
|
Problem Description:
unit will not heat up past 125 degrees F. Unit shuts down will not pressure up. also, leaks water on counter when dryer is on. |
|
Solutions |
| 1. In my understanding, you mentioned 2 problems: Question 1: Stops heating at 125F about Question 2: Leaks water when it is in dry. I am not fully understand these 2 questions. I do not know these 2 problems happened at same time or seperately. Your online message is too short. It is hard to tell you what is the reason. FYI Usually if the machine runs out of water, which will cause high temperature of the chamber wall, then it will automatically stop heating. But 125F is too low, even much lower then water boiling point. So it should be other reason. If these 2 problems always came together, then mostly the problem is the overheat cutoff out of work or the break/safety thermostat out of order |
|
|
|||||
|
The technical information is just to help sterilizer users as reference to do their trouble shooting. no guarranty implied. For each specific technical help to do with sterilizers or autoclaves, go to www.sterilizers.com ... or call 1-800-801-9934 Contact Us |